westerntruckandtractorrepair

Investigating the cause of the broken exhaust manifold on the 9620t.

Swapping out an international dt466 with a different dt466 with quite a few things that were unexpectedly different that made it quite a challenge.

Pulling an engine out of a s1900 international that has a window in the block.

Pulling an exhaust manifold and turbo off a 9620t John deere that obviously has an over fueling problem.

Swapping some components around on the 378 peterbilt, with some added commentary.

Replacing a broken shift tube in a 200 f250, and talking about hydraulics and other things that I do when I'm not wrenching.

Charging the nitrogen accumulators on the 75c challenger.

Pulling the 3406 B cat engine to replace it with a cummins that meets CARB compiance standards.

Replacing a front hub seal on a Kubota m135gx.

Pulling the injection pump from a john deere 6715 due to internal leakage pushing seals drom pump and installing a new pump.

Just giving you a preview of the 378 pete that we are doing the carb engine conversion on, pulling a B model Cat and installing an PX9 Paccar engine. wlrfixinit@gmail.com

Installing the axle and installing new tracks on the 75c challenger, 1 side goes really good but the other side i didn't leave myself enough room for my forklift so it took alittle longer.

After testing the system for fuel in coolant and not finding a leak, we attributed the fuel in water to a antifreeze jug that had red diesel in it in the cab, so now we are going back together.

Just wrapping up this project on the strawberry plant harvester and explaining some of the particulars of the strawberry plant nursery industry.

Putting the 9.0l John deere powertech back together and also finding a design flaw that caused the problem.

Tearing apart a John Deere powertech 9.0l that had a air compressor that seized and snapped the shaft causing the gear to bouncing aroud and damaging gear train.

Talking about current projects and upcoming projects.

Running around in cir cles on a new holland t7030 figuring out the park brake.

Trying to find out where the fuel is getting into the coolant system on a 2012 peterbilt.

Looking at a 7830 John deere that throws a high water in fuel code intermittently , and the sensor has been replaced already.

Another kingpin job , wishing I would have bought a kingpin press the last time I fought one.

Just finishing up the case 821b loader and getting it fired up.

I'm running like crazy trying to get this loader engine back in this case 821b loader so they can finish their season before it snows.

Pulling the front axle from the 75c challenger to remove the pivot pin and bearing.

Pulling the pressure regulator (not shown) and engine oil pump investigating a low oil pressure concern to end up pulling the engine on a case 821B loader.