westerntruckandtractorrepair

Starting the X15 Cummins for the first time and solving a couple more codes.

Going through the list of codes on the x15 Cummins and fixing problems.

Converting a 2010 367 Peterbilt that had a ISX cm871 to a x15 Cummins.

Thought I would have a quick fix on a Paccar mx13 which is going to wind up being a major job.

Running some new wires from the ECM to the vgt actuator.

Stripping an Isx Cummins down to bare block for machine work.

Brief video explaining all the different projects going on.

Tearing down a ISX cm2350 in a 2016 Kenworth T880 to find the cause of failure.

Finishing an in frame rebuild on a Cummins ISL9 that got dusted because of poor maintenance.

Finishing the 8235r john deere head job.

Replacing the head on a 6090 engine on a 8235r that is fighting me every step of the way.

Pulling the head off of a 6068 powertech with low compression.

Rebuilding a auxiliary section on a T660 Kenworth .

Pulling an Eaton RTLO18913a transmission to repair the range synchronizer.

Just showing the finished product on the hay squeeze engine and transmission project.

Getting my rear kicked by a Peterbilt that won't move.

Finding the problem with #4 cylinder on a 8235r and pulling cylinder head.

Doing some testing to determine the cause of a misfire on a 82235R .

Starting to see light at end of the tunnel. Doing more fabrication and finally driving it out of the shop.

Replacing the input shaft, clutch, and resealing the flywheel housing on a 2013 389 Peterbilt.

Helping a customer change his injection pump an old 6x6.

Going over a few problems with the hay squeeze retrofit.