3DsNutz

Just a quick look at my Ender 3 NEO printing at 200% speed without any special equipment. It can be done. #ender3 #neo #3D #garolite #creality

Here is a VERY SHORT clip on how to check if your model is lying flat on the build plate. In this clip though, the model IS already flat. I just want to show HOW to make sure it is. If it isn't your print will fail. If you're using a skirt, it will print a goofy looking shape, then try to put the model on top of that goofy shape. In my experience, it was some type of triangle, but it all depends on your model's shape. I'll make another quick one so people can see what it looks like when the model is NOT flat to begin with.

Just a quick before and after video of printing on Garolite (G10) print beds. Well, it's after printing but while the bed is hot and how it sticks and then how it releases once it's cooled. Here is the surface I used in this video https://amzn.to/3MN3lkQ

I'm guessing this is a bed adhesion issue? Why would it stick everywhere else but not in the middle? 3D Printing...Gotta love to hate it.