Black Dragon Production

I first started having problems with the K.C. Cobra Kiddie Ride (R7548) at Colonie Center Mall around August 26, 2021. The ride had no power for some reason. I used a continuity checker to verify that there was still power at the mall receptacle to rule that out as a possible problem. After spending a lot of time troubleshooting and tracing the wiring on this kiddie ride, I finally found out that the problem was a faulty timer in the ride that had stopped working. After removing the timer and bypassing it, the ride started working again, at least for a little while anyways. I went back to the mall for something else a few days later and noticed that the K.C. Cobra Ride was down again with no power! I spent more time trying to troubleshoot what was wrong with it through September and October, including meeting up with my Regional Manager at the time to have him help me try to figure out what was wrong with this kiddie ride. We finally narrowed it down to it must be a problem internally with the EMI Filter/Fuse/Switch box at the back of the ride along the frame where the power cable plugs into it from the mall power. So, I contacted CTM Group, Inc. Technical Support and ordered a new EMI Filter/Fuse/Switch box for the K.C. Cobra ride. Once I got the replacement EMI Filter/Fuse/Switch box from CTM, I then had to transfer over the original wiring harness and Molex connector from the old EMI Filter/Fuse/Switch box to the new one so I could plug it back into the power supply cable in the ride. But, the saga doesn't end there! It turns out that for some reason, the new EMI Filter/Fuse/Switch box that CTM Group sent me wouldn't fit into the original mounting hole in the frame of the kiddie ride! The new box was just slightly wider than the original box and I couldn't get it to fit in the original mounting location! After facing numerous obstacles and plot twists over several months, can I get the K.C. Cobra Kiddie Ride working again? Watch this video to the end to find out what happens... Thanks for watching! Make sure you subscribe to our YouTube Channel to be notified when we upload new content! - https://www.youtube.com/channel/UCsqNFiqok4mzwwIaIxgWd-A

I noticed that Mall Maintenance had put an "Out of Service" sign on the Plucky Ducky Crane Game on the kiddie ride platform at the Via|Port Rotterdam Mall in Schenectady, NY. So, I did some testing on it to see what the problem was with the crane. It looks like the claw solenoid is bad in it and not working properly, so I will need to order a replacement claw head unit to replace the faulty one in this machine.

The Freedom Convoy Continues to Trigger Guests: Michael Malice & Heather Wilson Originally Aired: 02/11/2022 Glenn Beck and Pat Gray discuss the latest on the Canadian Freedom Convoy and the hits that keep coming from the Left, including the Canadian government seizing donations. President Biden got a little frustrated during an interview with NBC's Lester Holt. Bill O’Reilly joins to discuss the news of the week, including Lester Holt’s interview with Biden, our economy, and how to fight the biggest threat facing our country. Author Michael Malice joins Glenn to discuss the Freedom Convoy, the redundancy of the Left's talking points, and Joe Rogan. Heather Wilson, co-founder of GiveSendGo, joins Glenn to discuss the Left and Canada’s attack on her company and donations seized by the Canadian government.

I was working at Colonie Center Mall on Sunday, January 30, 2022 servicing my vending machines and I had just finished up collecting from the photo booth down by the Barnes and Noble and Macy's when I started hearing this weird noise coming from the other end of the mall by the Macy's. So, I started walking down towards Macy's to investigate what was causing all the noise. I know from working at this mall for several years now that there is a pet store down at that end of the mall just off to the side of the entrance to Macy's, so I figured that had to be from where the noise was coming. Now, as I mentioned, I have been working in Colonie Center Mall for years, often late at night after the mall and all of the stores are officially closed. In all my years of working there, I NEVER recall hearing noises like these coming from the pet store there at the mall. I'm assuming that this pet store routinely has puppies for sale there, but I have never heard any puppies yelping and whining like this before whenever I have been working in the mall. So, I'm thinking something had to be wrong for these puppies to be yelping, whimpering, and carrying on like this. It looks to me like someone left a bowl of dog food on top of the "puppy aquarium" where these two puppies were being kept. Did an employee forget to feed these two puppies before they closed the store and left for the day? Were the puppies crying and yelping for attention because they were hungry? I'm not sure what happened that evening, but it certainly looked to me like these puppies were distraught over something. After filming this, I talked to one of the security guards in the mall about it, but it seemed like there wasn't really anything he could do about it. I'm guessing the security guards don't have keys to access the gates for the individual stores? The guard just kind of shrugged it off and said whoever opens the pet store on Monday morning will have to deal with it. What do you think happened? What would you have done if you were in this situation? Let me know in the comments below!

Walk-through of the COVID-19 deep cleaning performed on the platform kiddie rides at the Via|Port Rotterdam Mall on October 04, 2020. This was required by both the Mall Management as well as CTM Group before the rides could be re-opened to the public because of the Coronavirus Pandemic. Cleaners Used: Lysol 4 in 1 All Purpose Cleaner Disinfectant Spray - Kills 99.9% of germs/viruses; BioCide 100 Spray Cleaner. BioCide 100 - (EPA Reg #1839-83-86117) has demonstrated effectiveness against viruses similar to 2019 Novel Coronavirus (SARS-CoV-2) on hard non-porous surfaces. Therefore, this product can be used against 2019 Novel Coronavirus (SARS-CoV-2) when used in accordance with the directions for use against Hepatitis A virus on hard, non-porous surfaces. Refer to the CDC website for additional information. Additional Information: (https://www.cdc.gov)

Walk-through testing of Racer 80 Virtual Racing Simulator Kiddie Ride, ride number R8912, at the Via|Port Rotterdam Mall from October 04, 2020. This video outlines some problems with the ride currently and which parts need to be replaced on the ride to make it fully functioning again.

Walk-through of the ICV (Ice Cream Van) kiddie ride at the Via|Port Rotterdam Mall, ride number R6583, from October 04, 2020. There are numerous lights and buttons that are not working on this ride and need to be replaced.

Microphone test comparing the recorded sound quality between the Corsair Void Elite Surround Premium Gaming 3.5mm Wired Headset with 7.1 [Simulated] Surround Sound and the RØDE Stereo VideoMic X/Y On-Camera Condenser Microphone. I realize that this isn't really that useful of a comparison since a gaming headset isn't really a substitute for a professional microphone, but I just thought that I'd see how good the built-in microphone is on a $80 gaming headset compared to an expensive $250 professional condenser microphone. For more information on the Corsair Void Elite Surround headset, visit Corsair's website here: http://www.corsair.com/us/en/Categories/Products/Gaming-Headsets/Stereo-Headsets/VOID-ELITE-SURROUND-Premium-Gaming-Headset-with-7-1-Surround-Sound/p/CA-9011206-NA For more information on the RØDE Stereo VideoMic, visit RØDE's website here: http://www.rode.com/microphones/stereovideomic For more great videos like this one, be sure to check out my YouTube Channel here and Subscribe to stay up to date on my latest videos! - http://www.YouTube.com/BDPFilms

Many people who have lost their jobs as a result of the Coronavirus shutdown are having issues completing their Unemployment Benefit Claims online and over the phone here in New York. To highlight some of the problems people have been experiencing trying to complete their Unemployment Claims, I have tried calling the New York State Department of Labor's Unemployment Telephone Claims Center (TCC). This is the second day I am recording myself trying to get through to the Unemployment Telephone Claims Center. Will I be successful today? Please share your own experiences below in the comments, whether you live in New York State or not, since I'm sure this is affecting everyone across the country right now! If you would like to contact your elected representatives to let them know of your problems and/or concerns with applying for Unemployment Benefits, please use the following links below: Governor's Office: https://www.governor.ny.gov/content/governor-contact-form New York's U.S. Senators: https://www.senate.gov/general/contact_information/senators_cfm.cfm?State=NY Find your Congressional Representative: https://www.house.gov/representatives/find-your-representative Find your New York State Senator: https://www.nysenate.gov/find-my-senator Find your New York State Assembly Representative: https://nyassembly.gov/mem/search/ Find your New York City Officials: https://www1.nyc.gov/office-of-the-mayor/admin-officials.page

Many people who have lost their jobs as a result of the Coronavirus shutdown are having issues completing their Unemployment Benefit Claims online and over the phone here in New York. To highlight some of the problems people have been experiencing trying to complete their Unemployment Claims, I have tried calling the NYS Department of Labor's Unemployment Telephone Claims Center (TCC). However, I have yet to get through ONCE over the past week! Please share your own experiences below in the comments, whether you live in New York State or not, since I'm sure this is affecting everyone across the country right now!

GPU: GeForce GTX 1070 CPU: Intel(R) Core(TM) i7-6700K CPU @ 4.00GHz Memory: 32 GB RAM (31.92 GB RAM usable) Current resolution: 1920 x 1080, 60Hz Operating system:

GPU: GeForce GTX 1070 CPU: Intel(R) Core(TM) i7-6700K CPU @ 4.00GHz Memory: 32 GB RAM (31.92 GB RAM usable) Current resolution: 1920 x 1080, 60Hz Operating system:

GPU: GeForce GTX 1070 CPU: Intel(R) Core(TM) i7-6700K CPU @ 4.00GHz Memory: 32 GB RAM (31.92 GB RAM usable) Current resolution: 1920 x 1080, 60Hz Operating system:

GPU: GeForce GTX 1070 CPU: Intel(R) Core(TM) i7-6700K CPU @ 4.00GHz Memory: 32 GB RAM (31.92 GB RAM usable) Current resolution: 1920 x 1080, 60Hz Operating system: