Addressing a Honeywell Alarm Keypad
In this video, Joe shows users how to address a keypad on a Honeywell System. This is an important step when setting up a new keypad. In addition to wiring, setting the address allows for proper communication between the keypad and then panel. On a VISTA System, addresses 16 thru 23 are for keypads.
Addressing a keypad is completed when a panel is first powered up. Therefore, if you need to address a new keypad, you should power down your panel completely. Next, connect the keypad to the panel using a four-wire connection. Two wires are for data, and the other two are for power. Then power the panel back on, and the keypad should power on as well. Press and hold the [1] and [3] keys within 60 seconds of boot up. The keypad will display the existing address, which is set to (31) by default.
You can clear the current address by entering [00]. Then enter the address you want to use. It is recommended that you use (16) as the address for a first keypad. Then the second keypad can use (17), and so on until you reach (23) and no more keypads can be added. Additionally, AUI keypads like the Honeywell Tuxedo Touch will need to use one of the four AUI addresses. These are 1, 2, 5 and 6. Remember, the Total Connect 2.0 platform takes up one of these AUI slots. The AUI slots must be enabled using the programming field [*189].
Keep in mind that the addresses for standard push-button keypads must also be enabled from within programming. These are programming fields [*190] thru [*196] for addresses 17 thru 23 respectively. Please note that keypad address 16 does not have an associated programming field, and it cannot be disabled. Keypad address 16 is always kept enabled so that the system always has at least one keypad address available.
Note: It isn't mentioned because it technically doesn't have anything to do with the keypad address on the Tuxedo, but when Joe shows the ECP Address screen on the demo Tuxedo, it shows a checkbox for "Primary RIS Device" as being checked, and the RIS Address set to 25. When using Total Connect 2.0, you do NOT want this box checked, but you do want to set the RIS device address to 25.
-
3:31
Alarm Grid Home Security DIY Videos
6 months agoWireless Repeater: Use With Life Safety Devices
12 -
LIVE
Matt Kohrs
10 hours agoStocks Waver, Bitcoin Bounces Back & Live Trading || The MK Show
946 watching -
1:49:36
Bussin' With The Boys
8 hours agoTravis Kelce Talks Dating Taylor Swift + Winning Back To Back Super Bowls
8236 -
LIVE
Wendy Bell Radio
4 hours agoTapped Out
7,768 watching -
3:20:55
SNEAKO
9 hours agoLS LATE NIGHT - SECRET GUEST, DRAMA, AUTISM
66.2K73 -
3:06:28
Fresh and Fit
10 hours agoDo Sex Workers Deserve A Good Man?! HEATED DEBATE!
125K156 -
16:39
Stephen Gardner
11 hours ago🔴Breaking: Trump GETS HUGE boost as Jesse Waters Humiliates Biden!
45.4K133 -
39:42
Candace Owens
16 hours agoChrissy Teigen Needs An Exorcism | Candace Ep 11
69.9K123 -
2:32:24
Fresh and Fit
16 hours agoHow To Start A Business With NO MONEY!
97.6K13 -
1:42:10
Glenn Greenwald
16 hours agoU.S./Russia Tensions Escalate Over Ukraine to Most Dangerous Level Yet; CNN’s Kasie Hunt has Humiliating Meltdown; PLUS: Journalists Lee Fang and Jack Poulson on Israeli Influence Campaign on U.S. Campuses | SYSTEM UPDATE #288
114K146