In this video we go over the steps to remove existing shock strut on a Gen 2 Tacoma and replace them, in this case with struts provided by Flashark. I do go over the provided struts and give you an overview as well as the results in a brief test drive. On a quick note, the sequence I use here should be applicable to any vehicle that has front suspension struts and certainly applies to gen 3 Tacoma's. For anyone interested, below is a paid affiliate link to Flashark, which has a pretty decent selection of aftermarket automotive parts. They carry suspension, exhaust and other performance parts. https://tinyurl.com/342spxp2 Get a 15% discount if you use this code at checkout: DIY15 00:00 Introduction 01:25 Removing the Sway Bar Link 01:45 Safety! 01:57 Disconnecting Brake Line Brackets 02:17 Removing the Brake Caliper 02:37 Disconnecting the Upper Ball Joint 03:01 Removing the 3 Upper Strut Bolts or Nuts 03:50 Removing the Strut Lower Bolt 05:56 Remove the Strut! 07:06 Installing New Strut and Reassembly 07:32 Test Drive 08:18 Wrapping it Up #strut #toyota #tacoma #Flashark #FlasharkRacing #FlasharkPerformance #exhaustsystem #CoiloverSuspension #carparts #carperformance #aftermarketparts #exhaustcutout #CarEnthusiast #carlovers