Wood Turning a Log: One Tool Challenge

For this woodturning project, I challenged myself to only use one gouge. I did the whole project with my 1/2 inch bowl gouge, and it turned out pretty good, aside from some tool marks on the inside of the bowl. I really focused on practicing my pull cuts, and while I still need some work I was able to improve a little. Using a single tool was a fun challenge, so I'll challenge all you wood turners and lathe heads out there to give it a try! If you do, be sure to tag me in the video so I can check it out!

My tools:
Starbond Glue: http://bit.ly/2RFrayA (Use discount code "cook" for 10% off!)
Resin: https://amzn.to/2nUhFPg
Finishing Oil: https://amzn.to/2oAFPP6
Carbide Chisels: https://amzn.to/2NUiEdq
Face Shield: https://amzn.to/2Ac4Cvj
Center Finder: https://amzn.to/2ld06Ju
Jet Lathe: https://amzn.to/2qG2wD5
Nova Chuck: https://amzn.to/32tJvkm
Respirator: https://amzn.to/2N7mxfm
Miter Saw: https://amzn.to/2ZpjuBW
Drill: https://amzn.to/2XtnW0G
Square: https://amzn.to/2VaCNzW
Clamps: https://amzn.to/2UvPSiZ

*if you shop through these links I may receive a small commission. The price is the same for you, but it helps support me as a beginner woodturner in my quest to get a bigger lathe to make bigger projects, and I really appreciate it!

#woodturning
#woodworking