cohocarl

One frame/second

One frame/second

Terrible hand held video of Banks iDash on '23 Canyon AT4. Oh ya, terrible sound also. Highest manifold pressure I've seen is 22.5 psig.

Young fox didn't like the burned ham either.

Drove out to the rocket range on the tip of the Keweenaw Peninsula in Michigan. Set the camera on time lapse for the drive back to Copper Harbor. The editing in of the water crossings were deliberately made to hopefully inject some humor.

Came REAL close to smashing this into my face while mowing.

Over Traverse Bay, F/A18 demo, Red Bull and Thunderbirds.

Shot at 90fps plus slowed down to .125% in MovieMaker

Designed a 3d print to cut the bottoms out of K-cups to eliminate "bursting" of the foil lid. Has happened a number of times on both of our coffee makers. I believe what is happening is the poker in the bottom of the K-cup holder also pierces the filter inside the pod, (some brands more than others) gets plugged up with grounds, builds up pressure in the K-cup which ruptures the foil lid and makes an incredible mess. The cutter has a slot in it which holds a common utility knife blade just high enough to cut out a circular portion from the bottom of the K-cup so if the poker gets plugged up, there will be no pressure build up to burst the foil top. If the poker does pierce the filter and gets plugged, you may get a few grounds in your coffee, but not all over the kitchen. Use needle nose pliers to install the utility knife blade. STL file: https://www.thingiverse.com/thing:5678531

Original oil our of a Poulan Pro/Husqvarna 254cc/27" snowblower after 2 seasons, but low hours. Doesn't look too good.