Trencher42

Short little video of the little things we've gotten done.

Cleaned out the rotten transom and filled it with carbon-core. It's a short video mostly in high speed. They'll get more detailed when we're back in the boat working, Next part of the repairs will involve the 3D printer. CarbonBond Transom Compound https://www.carbon-core.com/products/carbonbond/transom-compound/

Winter Drive to work "Texas winter storm".

I didn't have allot to do on the boat without certain tools to dig out the transom so I screwed around and partially installed the depth finder.

I knew there was going to be a bit of rot, but wasn't expecting this much. No worries though, it just makes the job easier and less worry later on down the road.

This is just a montage of stuff I did over the weekend. A few hours of random footage crammed down into a short video. I'll put a better video together when rewire my rewire with better gauge wire. I just don't feel comfortable with the trailer wire for the harness. I think some 7-way neoprene jacketed trailer wire will be better. I can use the 10g black and white for the switch panel feed, The 14g Red, brown, green, and yellow for the switches, and the 12g blue for the bilge.

Ordered a handful of stuff from Amazon for the boat project.

Picked up a 1976 Skeeter bass boat up for 300$ for a winter project. Volume in the run down is low. I boosted it but still came out low. I'm still learning this video stuff.