NickAtNight

Spillway Radio Control Club Flyday on July 30, 2023 in Norco Louisiana. Academy of Model Aeronautics - AMA Chapter #979

Spillway Radio Control Club, American Model Aeronautics Chapter #979, had a Funday Flyday on July 27, 2023

Spillway Radio Control Club on Dennis Hymel Field in Norco, Louisiana

Flight of the Mamba Dennis Hymel Field Spillway Radio Control Club Norco Louisiana July 15th 2023

Flyday Saturday July 8th at Spillway Radio Control Club in Norco La

Flyday Saturday July 8th, 2023 at the Spillway Radio Control Club in Norco, La

Flyday Saturday July 8th, 2023 at the Spillway Radio Control Club in Norco, La

Some video of the magnificent Flyday we had this Saturday. The weather was amazing. The wind was light. All sorts of birds took to the air. From simple Carbon Cub trainers to sophisticated Corsairs and Jets.

Flyday Spillway RC July 8 2023

July 4th at Spillway radio Club in Norco La

July 4th Early Morning Flyday

Spillway Radio Control Club Flyday on a beautiful Saturday July 1, 2023

Horizon Hobby Carbon Cub Maiden Flight

Fly Day Bleakley Field Saturday June 24th, 2023

Initial setup of the Carbon Cub with the iX14 using the SAFE BNF template.

Carbon Cub Setup. So we went thru a lot of setup issues getting the iX14 to work with the Horizon Hobby Carbon Cub at the flying filled (Berkeley Field Norco La). 1. We cannot bind if the plane is upside down. Place the plane right side up and on a flat surface before attempting the bind. 2. Flashing blue light. The default model has the I button reversed. We were stuck with a flashing blue light for ages until we pressed and held the I button by accident. That moved us to a solid green light. (SAFE mode) 3. We flew the plane in SAFE mode (big mistake) and almost lost it. A. Solid Green light - Safe mode (B away from us) B. Solid blue light - Intermediate mode (B in middle) C. Solid red light - Expert mode (B towards us) 4. Change I (panic) button direction. If the I button is not set correctly, we remaine stuck in SAFE mode ! Press Model Adjust. Press Servo Setup. In Ax1 , make sure Servo is not reversed! Normal is 100, Activated is -100

Maiden Eclipson Go Wolf June 10 2023

Wooo Hooo. First successful #MMU2S print. It’s a Sheep. Baaa !!!

Took a day to setup the Prusa MMU2S feeder. Starting to run it. This one is the second attempt to print the Sheep (multi filament)

Printing in PETG Filamatrix Translucent Blue. 240 C/70C. Making a cover for my Mmu2 Prusabox

Step 5 Base parts

Currently printing an Eclipson Wolf in blue PLA. Going well. On the 12th part.

Nuts

Came out nice. Overnight print