Dredge Attempt #1
WE decided to break out the old Oshkosh flood pump powered by a Chrysler inline-6 4.0. We're trying to find the best way to dredge a pond. Doing this would remove much of the silt, muck, weeds, and other smaller debris that has accumulated since the creation of the pond in the 60s.
33
views
1
comment
Recoil Spring Repair
Quick video on replacing a recoil spring. I broke the original spring in the unit, unfortunately the exact spring was no longer in production. It appeared a polaris sportsman spring would suit my needs, looked right so I used it. I bought a kit for $15.00 on ebay.
38
views
1
comment
Restoring an Abandoned Motorized Surfboard: A Journey of Neglect and Ancient Parts-Pt.1
"Join us as we delve into the history of a classic 1980s SurfJet, a relic from the Minnesota-based company's heyday. Abandoned for over two decades, this early model Malibu board holds tales of past adventures. Follow along as we revive its former glory, tackling challenges like lost spark and broken recoil. Part 2 promises the thrilling climax as we aim to reignite its engine. Stay tuned for the revival journey! If successful, next up: mastering the art of refoaming a board. Ft. @TimcastNews @8:20 lol
61
views
67 Buick Special Deluxe Pinion Seal
1967 Buick Special Deluxe that was abandoned in Missouri, vehicle has been off the road for 18 years and sat without sparkplugs. The Buick 300v8 was broken free and seemingly came back around just fine. Carb was upgraded to a "truktok" carb, the tranny was bad (Th350) so an original ST-300 two speed auto with switch pitch was installed (sorry I didn't film any of this, it was fun). When this engine dies it will be getting the BBB 401 Nailhead. Hope you enjoy.
66
views
1
comment
1970 Camaro
1970 Camaro 252 3spd manual. Pretty neat car from California. Just a quick video seeing if it will fire up after years of sitting.
134
views
Eager Beaver Chainsaw repair
Cheap Chinese equipment broke again. Just a quick replacement of the fuel lines and sealing the tank penetrations.
55
views
Rust Repair on the Datsun
Just a little video of rust repair on the 280z. I cut out all the rust prior to this video.
30
views
1997 K1500 surging fixed
1997 K1500 surging, pulsing, and bucking -fixed! I replaced the TPS in err but wasn't a bad part to replace. The main culprit was the temp sensor's plastic housing snapping off. a little bit of super glue and it's great.
37
views
1978 280z big improvement
The 78 280z is doing better and finally running smooth, revving easily, and not smoking. We found something in the midst of plugged injectors, bad electrical connectors, and bad spark plugs.
23
views