Gaugster

Final Lokar shifter install. Took over 8 months to receive my custom order but so worth the wait.

First start of the new combo. Used makeshift shifter for cycling trans through it's main gears.

Adaptor plate bolted on. Review clearances.

TPS installation onto Quick Fuel 680CFM carburetor.

Talks about transmission alignment vs engine block.

Starter motor trial. Bolted up the torque converter to avoid any chance of tweaking the flex plate.

6 speed transmission fully seated onto Speed Gems adaptor/Ford 390 FE.

Clip of process to torque top, passenger side bellhousing bolt.

Final installation of 6 speed transmission onto motor. Additional clearance was needed in order to clear the flexplate/tunnel region.

Demo of a B&M oil cooler. Purpose is to cool transmission fluid from the electronic 6R80 6 speed transmission. Mounted in the passenger front wheel well.

First time the transmission was able to line up and rest on the dowel pins

Shows the progress and an issue I found during assembly.

Bellhousing end description - First Trial

Output shaft end of transmission. First trial.