DrSkip

Explanation as to why videos have not been coming out

I made a small mistake and want to help others avoid a similar mistake.

A pained video of discovery on the why's and how's of removing the axles and differential from the rear end housing.

Going thru setting up the Control Arms with the Coil Spring and Brake System.

Going back in Time--reviewing what it takes to tear down the A pillar and windshield channel to get it ready to build it back up. This is hard to find on any video platform out there, so this maybe a one-of-a-kind video.

Installing the new tubular control arms on the freshly powder coated frame. Tubular control arms are a challenge.

Reviewing all the work that has been done since the last episode of Season 1. Revving up for Season 2

There are really no other videos showing how to remove a dash panel. Well, you finally have one.

A quick video showing you how to remove the roof rail chrome without destroying the chrome

I found a cheap effective way to remove rust.

This is the last of my weekly videos for a short while. Getting all the junk off the frame. Stay tuned for the release of short videos here and there until Season 2 is ready

Continuing to clean up the frame by removing the control arms

Finally find the right formula to enable me to remove the tie rods and the upper and lower control arms. Persistence and never give up---even if you want to

I attempt to remove the front suspension, using many ideas from that other site (YouTube). Every attempt fails. Persistence will prevail, in the next episode.

Its time to get the front suspension off the frame. That starts with the drum brakes. One brake cooperates, the other makes things interesting

The body & frame are finally separated & I prepare the body for transport to have the floor & trunk pans replaced. Watch for a guest appearance that I didn't know about until editing this video.

All body mounts bolts are finally removed. The quarter windows are removed as well. Body is now ready to be separated from the frame.

Finishing the removal of the Side and Vent Windows

This video covers the initial stages of removing the side and vent windows, along with a couple of my own mistakes

Short video showing the removal of rear shocks and some of my mistakes

Digging into work needed to get ready to separate the body from the frame. Removing body mounts, reviewing what it takes to remove the windows

Introduction to the project, a 1967 Lemans. From tear down to the eventual future finished product