CharlieBSer

I'M TRYING TO GET A MESSAGE TO A CHANNEL THAT HAS MILLIONS OF SUBSCRIBERS . . . I have tried several times to get this idea over to Matt, even tried going through Fab Rats & Robbie Layton's channel comments but the communications through Y-Tube are so censored/squashed and the fact that Matt & the Fab Rats & Robbie have millions of followers it is next to impossible to make a comment that they will actually see & read! Perhaps some of you that see my comment here might know how to communicate with Matt's channel via 'SOCIAL MEDIA' and get this link to them? I'm 72 and a computer dinosaur...my skills are severely limited & I don't do Social Media, so...if you too like this idea, I would appreciate your help! I'm going to keep trying until I see in print or I am told..."WERE NOT INTERESTED!" ........THEN I'LL QUIT TRYING. Thanks folks...charlie irby PS....leave me a comment so that I'll have an idea of how many actually picked this up in the comments to the Wrecker video. (The Shocks Are BIGGER Than I Thought! World's Largest Wrecker Build) https://youtu.be/ThVmnJa_9R4

A scrap piece of 3/8's inch plate left over from another DIY project becomes a mobile welding table.

Another 'quickie project' in my 'Shop Spring Makeover'. My shop has been sorely neglected for too long...it's time for a 'do-over'.

Take an old 'not too useful' tool you may not use very often and turn it into a tool that has many more uses than before...

This is actually a poor review of a fine cast projectile, be sure to check 'WALTER BUNNING'S video here on rumble... (the SST 452-200-RF mold: results and conclusions) https://rumble.com/vxzjkw-the-sst-452-200-rf-mold-results-and-conclusions..html My video doesn't do it justice, I picked the wrong powder weight to start the testing and just had to keep rolling with it. My apologies for such a poor review to Rick.

Getting accustomed to a new machine...learning how to use the 'time in flame' feature for repeatability.

There's more wiring to be done and there's reed switches & a hall sensor to install before the 'In-flame' timer will register and before the RPM meter will display the RPM. When this is done...I'll be ready to work in the dark setting the annealing times. Stay tuned...I think it's going to work great.

Testing all sizes of cases back to back... This line-up includes 3 each of 30-06S, 8mm, 308W, 223 & the rimed 30-30WCF. The largest case tested in the feed-trough is a 300WinMag.