Richard Dunbar

View the full video here: https://www.youtube.com/watch?v=A54KYXUzeBE I clear a trail with a fecon blackhawk forestry mulcher. Cat 299D2 skid loader. #shorts

This video shows how to install and correctly wire a crane remote receiver. This can be used for many applications with electronic controls requiring 4 or more functions including: -Dumpster Roll Off Trailer -Skid Loader Attachments -Winch -Dump Trailer -etc. I have the Q400 crane remote, but the wiring process would surely be the same or similar for other 12v crane remotes. I am primarily using this setup for my sg30 bobcat stump grinder. I can now run the grinder from the front of the machine to make it easier to see what I am doing.

I show a simple solution that could be the reason your street bike runs for a moment then dies. This may apply to other bikes other than my 2005 GSXR 1000. This seemed like an electrical problem since the bike was surely getting fuel for the moment it ran, but it seemed as though a kill switch was toggling on/off. I checked the kickstand kill switch, and it was not that. It ended up being the Tip-over sensor was dangling by the wiring harness, and not mounted upright as it has to be to run properly.

This video was a test of various fps shots with the gopro hero 11. It is also my first practice attempt at editing with adobe premiere pro. This contains some shots of using the forestry mulcher attachment (fecon blackhawk) on the track loader (CAT 299D2).

I walk through the process of adding a plasma cutting section to my standard steel table that I use for welding and general fabrication. Something similar could be installed for any steel table, but each case would probably look a little different. Hopefully this provides some guidance or ideas for the structure/layout at a minimum. This work was done using a cheap amazon plasma cutter and a Hobart welder.

Moving snow with the CAT 299D and a sectional snow pusher over a gravel parking lot! This video merges drone footage with in-cab operation footage. Audio: "BOSS" - SkagBeats "Footsteps" - Chillnrelax