Lance's Garage

Modifications to a 1995 former Rusty Wallace Nascar Trailer to transport and store motorcycles to make room for winter project work. Modifications include connecting Harbor Freight 61670/97841 Motorcycle Stands to 2 inch angle aluminum and securing them to the aluminum floor of the trailer with some Tow Rax PH2770 wheel chock mounting hardware.

This video covers brake pad installation on a 2007 Harley Sportster. Easy installation.

This video covers the installation of the Burger JB4 Group 17 on a 2022 MK8 GTI. This car already has an ECS catback exhaust, Racingline R600 intake, and is lowered. Owner is very happy with the results.

In this video I fix a wiring problem with hand control wiring extension kit on a Harley Sportster. Have to remove the fuel tank on a 2008 Sportster to fix the connection.

This is an overview of my 1989 Sportster hardtail bobber that has DNA Springer 2 under front end, 4 inch stretch Led Sled weld on hardtail, custom jackshaft, foot clutch, and jockey shift. This is my first chopper built with the help of the guys over at Dirty Hands Choppers in 2008. I also install a new Pingel petcock to replace a poor purchase a few years ago. This was to get the bike ready for Smokeout 2022 in Salisbury, NC.

This video shows the installation of a Secondary Air Pump Filter on a 2022 MK8 GTI with a Racingline R600 intake. I go over trying to place it where it would go on an MK7, then a second location, and then show the final location that worked best.

2022 MK8 GTI Cabin Noise with ECS Exhaust Racingline R600 Intake and Turbo Inlet System

Installation video of the Racingline R600 "EVO" intake, Turbo Muffler Delete, and Turbo Inlet pipe on a 2022 MK8 GTI.

Installation of Racingline VWR (VWR31G8GT) Sport Springs on a 2022 MK8 VW GTI.

Installation video for an ECS 4465030 Non-Valved Catback Exhaust System on a 2022 MK8 VW GTI.

Front Brake and rotor replacement video for a MK7 Golf (Alltrack in this video). ECS Brake Service Kit ES# 3543545.

Purchased a "Running" LS 6.0 LQ4 motor someone else pulled out of a 2004 Chevy Express van with only 61,500 miles on it (but apparently not recently). Motor turned over with breaker when purchased. 45 days after purchase wouldn't turn over. This video covers the diagnoses, and a full teardown of the motor to discover the issue. This is the first motor I have ever torn apart. While I wasn't expecting to do it with this motor at this time, this was something I have always wanted to do. Sometimes you have to get out of your comfort zone sooner than you wanted to. Enjoy the video and hopefully you will find some good tips I found in other videos and combine into this one.

In this video I unbox Eastwood's EZ Turn Engine Stand and Assemble it. I purchased the stand to work on a LS motor that I recently purchased.

Review of the new Harbor Freight Titanium Multiprocess Welder. Follow-up to the unboxing video. I'm not a welder, and this video proves it, but check it out to see how it is for a beginner welder that does MIG, TIG and Stick welding in a 120V only unit.

Unboxing video of the new Harbor Freight Titanium Unlimited 140 Multiprocess Welder. 120V MIG/Flux/DC TIG/Stick welder.