DustinD523

Designed & 3d printed a paper tray for a printer 🖨️at work. This is not like the original piece that broke off but a simpler design. Turns out it works pretty good.

I couldn't load filament in the extruder. I tried bending the filament for different angles. Cleaned underneath and seen no blockage. I looked from the side and it looked like there was filament blocking the hole. Carefully used the exacto to break it up and a needle to check the inside. Put it all back together and was able to load and print again. This is a Flashforge Dreamer NX 3d printer.

Flashforge Dreamer NX 3d printing a skull 💀 keychain with PLA filament.

2022/09/29 rough trading day