K3N For America / For The Republic

A short discussion about the importance of HF communications for intel during SHTF, rural implementation, and implementation of the slim Jim antenna as well as a home brew tri-band HF antenna.

A quick table top review of the Crye Precision G3 Combat Pant in Khaki with Khaki knee pads.

Nothing special. Was just already out in the woods so thought it a good time to verify functioning Ham Radio Communications. HF and UHF via Yaesu FT857D. Not a ham nerd... it’s a means to an end... a tool. Particularly a good time to sure up Communications with the threats of nukes nowadays... which could take all traditional Communications off line as well as the pier grid.

Modifying the iCom 2730A to allow transmitting on GMRS frequencies, since I hold a GMRS license. When transmitting on GMRS, be sure to set the radio to low power, which is 5 watts, which is the maximum allowed power on GMRS with a license. I believe GMRS without a license only allows 1/2 watt and does not allow any after market antenna. Not responsible if you brick your radio. Do at your own risk. Also, be sure to abide by the FCC regulations and not do this if you are not licensed to transmit on the frequencies it opens up. Video provided for educational purposes only. http://radioaficion.com/cms/ic-2730-mod-frequency-expansion/

Running over my plate carrier and battle belt setup as well as IFAK (medical). Each of us will have different views, missions, or anticipated threats that our kits are setup to deal with, so your needs will undoubtedly vary from mine. I am just putting this out there in case it can help anyone. There have been times I have searched videos for other peoples setups when I was dealing with a certain problem. Update: The chest seals I use, each individual one already has an entry and exit wound seal so no need to pack a two-pack. Update: The radio pouch is; OneTigris MOLLE Radio Holder Tactical 1000D Nylon Short Radio Pouch. Update: Water bladder holder; Tactical Assault Gear MOLLE Hydration 50oz Bladder Carrier, Small. Using CamelBack water bladder. Some of the products mentioned: http://www.ronintactics.com/store/p54/Ronin_Assaulter_Lite_%28AL%29.html http://www.ronintactics.com/store/c12/Belts.html http://www.ronintactics.com/store/p55/Medical_%22Pull-Away%22_Kit_%28P%2FN%3A_50378%29.html http://www.dkxarmor.com/ http://www.highspeedgear.com/hsgi/m3t-12M3T0.html http://www.highspeedgear.com/hsgi/x2r-taco-112R00.html https://www.blueforcegear.com/ten-speed-ultralight-dump-pouch.html http://www.skinnymedic.com/

Getting back into priming/practicing for team movement drills with individual bounding with standing kneeling and prone. The drill starts at the 60 and goes back to 75-80. Closest shots standing, middle kneeling, furthers prone. One hit then move. Fight back(ward) and then fight (assault) forward, bounding between available cover.

Been way to long since taking the opportunity to run some night vision drills. Individual bounding between cover with NODs. Pretty dark out tonight. Had some extra ambient light about half way down the range. Running full kit (full battle belt, carrier with plates and OpsCore ballistics helmet. And when I say full kit, I mean one that is loaded full enough for me to travel and get through most anything. Like I said, been a while. Next time will get lower and move quicker. Half of the videos are running a PVS-14 and filmed through a PVS-7. The other half the opposite. Running Inforce WPL/IR light and DBAL I2 IR laser. Had one malfunction where my pressure switch plug came out of the DBal.

For quite some time I had intermittent problems with the bolt not locking back after the last round. At first it was just some old G.I. mags that I had used heavily for years, so I marked them each time they failed and was going to replace them. But then it happened on more of them, but not on PMags. I went ahead and pulled the BL but then later decided "No, I want it". Then after a while it started happening with PMags. I had dug for a solution for quite a few months here and there. Lots of people were having the problem, and most suggested it could be a variety of things, but I found no real solution. Knowing that my rifle already had pushing 20,000 rounds I went ahead and replaced the bolt catch. But that didn't fix it. Then one night while troubleshooting it by looking at all of the mechanics involved, I discovered this. I hope it helps as it seems like a lot of people are having this issue. Even if you're not, it is something to consider when buying parts for your AR as you may want to more closely evaluate what anti rotation pins and/or speed lever you want to use.

First time running this range drill. Need to work left handed, more holes (we did left/right handed later but too dark for good Video) and other things but it's a start. We ain't no Costa or Haley but fun to experiment with.

Putting the finishing touches on my Ronin battle belt. T-Rex Arms light compatible Ragnarok for Glock 19/17 with Inforce APL. Safariland UBL mid ride with thigh strap.

A quick communications equipment suggestion for fellow patriots and patriot groups. My experience with the stock Baofeng UV-5R and BF-F8-HP earpieces. Pryme SPM-1301-BF and SPM-2301-BF

More from California. Thank you for your stand Patriots. WRWY.

Credit: TJ Johnson. ThanQ Patriots! https://www.facebook.com/profile.php?id=100039117920766

We are going to take our country back! By any means necessary!!! #RiseUp #JesusMatters Thank you for your stand fellow Patriots! We are with you. WWG1WGA 🇺🇸 Note: This video is from her Facebook live video. Re-uploaded for easier sharing over other platforms. Original video: https://facebook.com/story.php?story_fbid=188301856059567&id=100046392601723

You are going to LOVE how this movie ends. Get ready folks. Military planning at its finest!

From the movie "Shooter" with Mark Wahlberg. MSM coverage? When you control the media, you control public opinion. Q https://qalerts.app/?q=MSM%7Cfake+news%7Cfakenews

What the hell did I just watch? Panic in D.C. Q drop 3731 Puppet following orders. Q https://qalerts.app/posts/?n=3731