Keith Fenner, Career, Hobbies and Life

We are back on the refurbishing of our 1970 Bridgeport mill, all starting with replacing the spindle bearings. We pick back up where we were, tearing down so we can clean inspect and paint it before putting it together, Part Four we assemble the knee and over arm or ram for the spindle head. The footage in this video was mostly done on the Note 10 S due to an accident with OSMO +. To watch and keep up on all my short clips and pic that use to be on Facebook, go to my MeWe site. mewe.com/i/keithfenner

We are back on the refurbishing of our 1970 Bridgeport mill, all starting with replacing the spindle bearings. We pick back up where we were, tearing down so we can clean inspect and paint it before putting it together, Part Three, we paint and start assembling buffy, with painting without over spay and a sample repacking of the leather lip seal bearing number #W306PP3 a special order by FAFNIR for Bridgeport, in 1970. To watch and keep up on all my short clips and pic that use to be on Facebook, go to my MeWe site. mewe.com/i/keithfenner

Today we start back on the refurbishing of our 1970 Bridgeport mill. We pick back up where we were, tearing down so we can clean inspect and paint it before putting it together, this Part in out series we remove the table and slide from the knee of the mill.

So you bought a new machine, I take you through the process to find out if My purchase of this K&T #2 Plain mill was worth the value I paid for it. I talk a little bit abought what to look for and should have done before your new purchase when buying used machinery.

Setting up a line bore project in the Sibley drill press to line bore a Wain Roy coupler. Part Two will be a Rumble exclusive presentation, Using the jigs and fixtures to line bore the coupler, for a new set of sleeves, concluding the video with a glimpse of our new Hot Shot heating oven.

Demonstration of a lap fitting on a prop, for boat owners, what you should expect from a reliable shop or need to know to getter done your self.

Demonstration on lapping a prop for the average boat owner, what you should expect from a reliable shop or to getter done yourself.

Setting up a line bore project in the Sibley drill press to line bore a Wain Roy coupler. Part one making up the jig and fixtures. Part Two will be a Rumble exclusive presentation.

Using the wood stove to heat treat a pair of pins.

My second Video created during a Babbitt pouring and sharing the process from start to finish, I had the radio playing in the background, so I will not Monetize this video.

I share a catching trip out to the canyons, the continental shelf off the Atlantic coast , our destination is out 120 miles from Cape Cod.

We have an update on the tanks we are building to replace the 25 year old tanks in the 45 foot Young Brothers vessel we are sharing in some of the fun of refurbishment. We create the spill way for the fill necks on the top of the tank. ;{)

A look inside a Job Shop, thats repairing America one project at a time! Meet the owner and see a few of the projects he's taking on!

We have an update on the tanks we are building to replace the 25 year old tanks in the 45 foot Young Brothers vessel we are sharing in some of the fun of refurbishment. we also share a modification during mid stream, to make room for the serge tubes, which turned out to be a bit fatter than planned. Finishing up the video with a glimpse of the accessories we plan on adding to the top cover of the tank, before welding it in place. ;{) My New MeWe Page, way better than Facebook ever was; mewe.com/i/keithfenner New group of kids from Rocky Bog, say the pledge.

Sometimes a repair takes you on an adventure disassembling a component that is not held together by fasteners, lending to a little reverse engineering. press and form shapes sometimes can be taken apart and closed back up and keep on working just fine.