Ebike Hall Sensor Replacement - 48v 500w Motor (SS41F/41F/S41)

2 years ago
68

*Ignore the message at 2:18, Not sure how that got there but it was supposed to say "Note where the phase colored signal wires go as to not mix them up, It can become out of phase but typically will just operate in reverse operation."

Hello folks, 🔋BattTube here. Today we will be replacing the Hall Effect Sensors in a 48v 500w E-Bike Motor. The hall effect sensors in this motor are 41F's but go by several identities "41F/SS41F/S41/SH41/0H41". Only one was bad but it only made sense to replace all 3 seeing how cheap these are, Even paying $15 for 10 which are worth pennies in bulk. The Hall Sensors make use of the magnetic fields of the changing phases to determine RPM which can then be derived into speed.

👍🔔 Thanks For Watching! 🔔👍
Please Like and subscribe if you enjoyed it and click the bell icon to keep up to date with new uploads when they are released!

📰❤️Follow & Support❤️📰
Patreon - https://www.patreon.com/BattTube
Utreon - https://utreon.com/c/BattTube
Facebook - https://www.facebook.com/BattTube
Discord - https://discord.gg/dCdFF35b
Rumble - https://rumble.com/c/c-1430223

💰🛒 Linked Products 🛒💰
*Amazon affiliate links
10x Bestol SS41F 41F/0H41/SH41/S41 Bipolar Hall Effect Position Sensors:
CAN - https://amzn.to/3tOfKLu
US - https://amzn.to/3qFoNMP

💰🛒 Products I use 🛒💰
Lomvum 6000c Multimeter:
CAN - https://amzn.to/3J4BIiw
US - https://amzn.to/3HOUxVx

Baku 601D Hot Air + Solder Station (Hako knockoff):
CAN - https://amzn.to/3Cl24dQ
US - https://amzn.to/3CkTDzf

CHEAP PCB Spot Welder:
CAN - https://amzn.to/3Kr1Xjy
US - https://amzn.to/3pKsWia

Sunkko 788H Spot Welder:
CAN - https://amzn.to/35TE9WG
US - https://amzn.to/3IURAUP

Wire Strippers:
CAN - https://amzn.to/34lmRkK
US - https://amzn.to/3HQ28Dt

Mic - Blue Snowball:
US - https://amzn.to/3HVnDCO
CAN - https://amzn.to/3HPAwOU

💡💭 If you have any suggestions or ideas for future videos please be sure to leave them in the comments section below! Thank you. 💭💡

Chapters:
Intro & Motor explaination. - 0:00
Shroud Removal. - 1:12
A look inside & What is a hall sensor? - 2:05
Removing the old hall sensors. - 3:09
Prepping for the new sensors. - 8:36
Soldering the new sensors. - 16:37
Soldering timelapse. - 21:03
Installing the hall effect sensors! - 24:17
Securing the wires - 26:57
Installing the motor shroud - 29:40

Loading comments...