Shed Roof Rafters - Build Truss system - Video 3/17
The trusses are build right after the platform is complete. There are a couple reasons for this. The platform can be used as a flat level surface to work on. This will keep consistency in the trusses. The next reason for building at this stage is to use the edges of the platform so each truss overhangs the building equally. When I build trusses I start off by marking the center line on the shed floor. Then I place the 2x6 down so that the lower edge touches the corner of the shed. I then move the center end up until I have the pitch that I need. To keep each truss consistent I like to screw down some 2x4's to make a template. Once I have the lumber where I want it I then cut the angle on each side and match up the boards to a point. These two are held together with plywood gussets and liquid nails adhesive. Screws go in to hold the gussets together while the adhesive set.
-
12:32
Land To House
2 years ago $0.01 earnedBuild a Shed - Frame a Basic Shed Wall - Video 4/17
109 -
16:36
Land To House
2 years agoBuild a Shed - Porch Awning - Video 10/17
83 -
9:04
Alanvale and the Lazy Farmer
2 years agoBuilding the kit home 14 - Roof trusses and bracing
11 -
3:42
Alanvale and the Lazy Farmer
2 years agoBuilding the kit shed 5 - Raising the trusses
23 -
2:44
Mill Canyon West
1 year agoAg Buildings - Building Barn Roof Trusses
16 -
3:01
Morewoodworkingdotcom
1 year agoGarden Shed Woodworking Project
7 -
5:53
Tekton Home Construction
1 year agoDIY HOME BUILD | EP. 41 PLACING ROOF TRUSSES
1 -
14:08
primitivetechnology9950
9 months agoPrimitive Technology- Tiled Roof Hut
50 -
12:38
yophotoman
1 year ago $0.01 earnedDIY Off Grid Shed build, Part 2: Framing Parts
761 -
0:59
Andrew Thron Improvements
1 year ago $0.02 earnedHow to Build a Modern Shed Episode 5: How to Frame Lean To Shed Roof
67