Dust Collection Upgrade - Delta 36-725T2 and Longmill CNC

In this video I move my table saw and my CNC from the stock hose into a shop vac to an eccentric / offset reducer for use with my 4" dust collection system. With the knowledge that any restriction in the collection will reduce the effectiveness of the dust collector, being able to run either piece of equipment without constantly paying attention to a 5-gallon container is a plus. This upgrade also improved the dust collection for my CNC immensely.

Note - the eccentric element of this reducer was needed to fit the Longmill's dust collection shoe and still have room for the hose to attach.

1/4" shank 1" Surfacing Bit https://amzn.to/3vWI2DC
Eccentric Reducer, 4-Inch to 2-1/4-Inch https://amzn.to/3vIVpIM

If you liked this video, please be sure to share it with others you might think would find the content helpful, hit the like button, subscribe and turn on notifications so you'll be notified when I post future videos.

DISCLAIMER : This video description contains affiliate links which means that if you click on one of the product links I may receive a small commission on a purchase without additional cost to you. If you do purchase through my affiliate links, thank you for supporting the channel.