Model Railway Wiring for Block Detection in DCC - part 3
2 years ago
11
How to wire for block detection in DCC -- part 3.
I am extending my layout from the storage area up towards the main scenic layer. Part 1 covered basic physical installation, wiring and electronics. Part 2 covered basic software configuration using FLiMConfig and JMRI. In this third part I'm covering more advanced topics, with bi-directional sections configured for ABC braking in both directions, plus a DCC reversing section controlled from the route setting (not using any short detection).
Loading comments...
-
2:46
Throwingbull
3 years ago $0.02 earnedModel Trains at the B&O Railroad Museum
971 -
3:47
SteveMassikker
3 years ago $0.32 earnedThe Modern DC Control Wireless System for All Model Railways
161K2 -
4:17
TrainFans
2 years agoCN 2299 & CN 8873 Engines Manifest Train Eastbound On Strathroy Sub TRACK SIDE
10 -
2:27
TrainFans
2 years agoCN 8844 CN 2598 & CN 5710 Engines Manifest Train Eastbound On Strathroy Sub TRACK SIDE
9 -
36:43
lonewolfe777
4 months agoHow to install a DCC PNP Decoder for your locomotive Part 1
7 -
19:27
jimwor
2 years agoModel Railroad Sensors (Part 2)
4 -
3:06
Nobel200
3 years ago1960s Matchbox Motorway powered by Model Railway controller
177 -
8:34
TrainFans
2 years agoManifest Train 492 Eastbound On Strathroy Sub With CN 2314, CN 5731 & CN 8931 Locomotives TRACK SIDE
25 -
42:25
jimwor
2 years agoModel Railroad Sensors (Part 1)
3 -
1:07
Dongits Model Railway
3 years ago $0.01 earnedModel Railway - Train Detection
3631