17. Part 5, Lee Factory Crimp Die and Tolerance Stacking
2 years ago
37
Holland micrometer
micrometer
holland neck thickness micrometer
Lee factory crimp die
handloading
reloading
cast bullets
bullet casting
swage bullets
44spl
charter arm bulldog
We gotta think about the tolerances! You may be surprised about how the thickness of brass cases can vary from brand to brand and even lot to lot. This video is not "empirical", but anecdotal. This is a small sample of cases and measurements but it should be enough to allow one to realize that differences in tolerances can lead to stacking issues. The way tolerances stack can cause problems with the FCD. Lets explore this phenomenon!
Loading 2 comments...
-
0:26
AllVisuals4U | 3D Printing & Design Shorts
10 months ago🚨 How To Fit Two 3D Printed Parts - 3D Print Tolerance - 3D Print Joints
2 -
2:46
ScenicDriveways
1 year agoUsing the Lee Factory Carbide Crimping Die
8 -
3:26
Cooks Saw Mfg., LLC
3 years agoTips on Stacking and Drying Lumber Part 2
471 -
12:40
Cooks Saw Mfg., LLC
3 years agoTips on Stacking and Drying Lumber Part 1
233 -
9:47
76Highboy Reloading
1 year ago $0.10 earnedV9, Lee Six Pack Pro, Lee Factory Crimp Die Setup and Adjustment
3951 -
20:56
DIYReloading
3 years ago $0.07 earnedHow to setup a Full Length Sizing Die
448 -
5:55
ThebackwoodsMechanic
2 years agoLisle Magnetic Soldering Clamp #55000
61 -
0:45
ARguns1776
1 year agoRedding Steel Die Set, 9mm part # 80172
233 -
2:32
USmodernCoinErrorsUploads
1 year agoModern 2000 Lincoln Cent Die Break, Blisters,Doubling
10 -
9:40
76Highboy Reloading
1 year ago $0.02 earnedV14, Dillon RL550C, 223 Remington, Taper Crimp Die Setup
531