Make this DIY super easy, super cute, indoor/outdoor Christmas Tree

Fill a 5 gallon bucket (https://amzn.to/3xvApUZ) with sand (https://amzn.to/2ZsX33J). Cut a 2 inch hole in the center of the lid of the bucket. Cut a piece of 1 1/2 inch PVC to 7 feet (https://amzn.to/3cSEwku). Put pvc (you can buy a 8 or 10 foot length at your local home improvement or box store) through the hole and secure into the sand. Cut the RV insulation (https://amzn.to/3rgItYQ) into 2-3 inch strips starting with 48 inch long strips. Then after 4-5 rows (20-25 strips) shorten the strips by 6-8 inches every 4-5 rows. You may need 2 rolls. I'm not sure because I uses some that I had left over from our travel trailer. Tape (https://amzn.to/3rbyZxT) on end of the one of the longest strips onto the bottom of the pvc. Do this in 4 directions and then go back and get the other end and tape it and inch or 2 to the right of where you started with that strip. This creates a loop that is slightly twisted. keep doing this starting from the bottom of the tree and moving upward until the tree is full. Then hook the curtain lights (https://amzn.to/3CYEBhf) to the top of the pvc and drape them down the tree while pulling them through the loops. Use the duct tape to create a cap around the hooks at the top of tree. Plug it in and enjoy! So beautiful and so easy!

As an Amazon Associate, I earn from qualifying purchases.