WIldfire Lift Last Part. She takes 10 bearings & it was a bit#h to change a few of them. Tips Too!

One pin would not come out short of drilling a hole in the runway and banging the pin out. 6 hours and labor and $250 of SKF bearings to do the job. There are some other tips you need to see about the hose and don't leave the ramps on. If you don't have a press or some pretty good skills and other tool this bearing change over can be VERY dangerous. Don't do it if you feel it is beyond you in any way but then again you'll need to keep a sharp eye on ALL of your bearings and listen for ANY noise at all. I don't know how to advise you so I'm just saying to PLEASE be safe and I'm sure Wildfire Lifts will talk to you and help you.