【Motorcycle】Install Cruiser Motorcycle Lift on Class A Motorhome I Tiffin I Phaeton

We installed #CruiserLift to hauling our #Indianmotorcycle on our #Tiffinmotorhome, Phaeton.

At first, we used pull strap tie downs. Later on, we use 7 ratchet straps on the bike to secure. One additional strap wraps the front tire to the tray/chock. Two more ratchet straps on the leading side to the RV frame / hitch. It should also be noted that you do not want to compress the front suspension fork more than 50% or you run the risk of damaging the fork seal. The lift is not supported by the cable. Once it is winched into travel position, you put pins through the arm to lock it in place. Then you release the tension on the cables and all the weight rests on the pins.

We had problems with the bike bouncing when going over overpasses. We ended up adding rubber shims at the gap of the top where the movement occurred. That helped a little. We didn't use cover because I found that the cover rubs the paint in the wind so unless it is a really soft cover this is not good.

💢 Follow #LaVieFlottante​ on social media!

👉 Patreon: https://www.patreon.com/lavieflottante​
👉 Website: https://lavieflottante.com/​
👉 Instagram: https://www.instagram.com/lavieflottante