Voron V0 Build - E16 - Software and Firmware config
2 years ago
9
This week it's time for getting the software and firmware setup and configured for the printer. It's not too hard a process, but it does take a little time and there are some pitfalls to avoid as well. Discord Link: https://discord.gg/Dzke8e6
Loading comments...
-
21:01
A little bit of everything
2 years agoVoron V0 Build - E15 - Toolhead wiring
25 -
20:28
A little bit of everything
3 years ago $0.01 earnedVoron V0 Build - E02 - Z-Axis Carriage
23 -
6:24
A little bit of everything
3 years agoVoron V0 Build - E01 - Bed Prep
23 -
18:33
A little bit of everything
3 years agoVoron V0 Build - E04 - Frame Assembly
31 -
30:39
A little bit of everything
2 years ago $0.02 earnedVoron V0 Build - E11 - Toolhead assembly
23 -
51:58
A little bit of everything
2 years agoVoron V0 Build - E14 - Wiring the Electronics
55 -
23:21
A little bit of everything
3 years agoVoron V0 Build - E03 - Z-Axis Motion
4 -
25:10
A little bit of everything
2 years agoVoron V0 Build - E9 - Gantry Assembly 37/100
43 -
33:56
A little bit of everything
2 years agoVoron V0 Build - E10 - Feet & Belt routing
13 -
17:42
A little bit of everything
3 years agoVoron V0 Build - E05 - Frame Squaring and More
52