Voron V0 Build - E15 - Toolhead wiring
4 years ago
28
This week on the build it's time to get the toolhead wired and tied into the control board. We are very close to being able to run this printer. Next up is configuring the software which we will cover next week. I hope to see you then and fell free to hop into the discord and chat. Discord Link: https://discord.gg/Dzke8e6
Loading comments...
-
30:39
A little bit of everything
4 years ago $0.02 earnedVoron V0 Build - E11 - Toolhead assembly
49 -
51:58
A little bit of everything
4 years agoVoron V0 Build - E14 - Wiring the Electronics
59 -
20:28
A little bit of everything
4 years ago $0.01 earnedVoron V0 Build - E02 - Z-Axis Carriage
28 -
6:24
A little bit of everything
4 years agoVoron V0 Build - E01 - Bed Prep
35 -
18:33
A little bit of everything
4 years agoVoron V0 Build - E04 - Frame Assembly
67 -
23:21
A little bit of everything
4 years agoVoron V0 Build - E03 - Z-Axis Motion
4 -
25:10
A little bit of everything
4 years agoVoron V0 Build - E9 - Gantry Assembly 37/100
45 -
33:56
A little bit of everything
4 years agoVoron V0 Build - E10 - Feet & Belt routing
16 -
17:42
A little bit of everything
4 years agoVoron V0 Build - E05 - Frame Squaring and More
61 -
25:41
Robbi On The Record
10 hours agoThe Billion-Dollar Lie Behind OnlyFans “Empowerment” (Her Testimony Will Shock You) | part II
3.71K6