Voron V0 Build - E15 - Toolhead wiring
2 years ago
25
This week on the build it's time to get the toolhead wired and tied into the control board. We are very close to being able to run this printer. Next up is configuring the software which we will cover next week. I hope to see you then and fell free to hop into the discord and chat. Discord Link: https://discord.gg/Dzke8e6
Loading comments...
-
30:39
A little bit of everything
2 years ago $0.02 earnedVoron V0 Build - E11 - Toolhead assembly
23 -
51:58
A little bit of everything
2 years agoVoron V0 Build - E14 - Wiring the Electronics
55 -
20:28
A little bit of everything
3 years ago $0.01 earnedVoron V0 Build - E02 - Z-Axis Carriage
23 -
6:24
A little bit of everything
3 years agoVoron V0 Build - E01 - Bed Prep
23 -
18:33
A little bit of everything
3 years agoVoron V0 Build - E04 - Frame Assembly
31 -
23:21
A little bit of everything
3 years agoVoron V0 Build - E03 - Z-Axis Motion
4 -
25:10
A little bit of everything
2 years agoVoron V0 Build - E9 - Gantry Assembly 37/100
43 -
3:00
DanInTheDirt
2 years agoWiring Update #2 Dodge W300 Cummins 4bt Build
20 -
6:55
DanInTheDirt
2 years agoWiring update #1 Dodge W300 Cummins 4bt build
13 -
33:56
A little bit of everything
2 years agoVoron V0 Build - E10 - Feet & Belt routing
13