holley sniper efi initial setup

In this episode, i take you step by step through the Holley Sniper EFI setup and review the parts needed to make it work.

We walk through the basics of setting the distributor to initially set the timing. Starting with setting the engine at 14 degrees before top dead center (TDC), then show you how to determine the correct location for the distributor rotor to be pointing.

Next, we discuss the components we use on this build including the Holley Sniper EFI, the MSD 6 EFI controller and the MSD distributor, and lastly the MSD blaster coil.

As this build is supercharged we have selected an MSD distributor with no vacuum advance mechanism and we have disabled the distributor's mechanical advance system. The Holley Sniper EFI will be programmed to control the timing of the engine throughout the entire engine rpm range. Which will optimize the fuel and timing to make the most power and create the best fuel economy as the SNIPER is constantly learning and will make slight adjustments to improve the experience driving every time it's running.

Components of the ignition system are;

Holley Sniper EFI Model 4150 https://www.holley.com/products/fuel_systems/fuel_injection/sniper_efi/sniper_4bbl_tbi_kits/

MSD 6 EFI Controller
https://www.holley.com/products/ignition/ignition_boxes/street/parts/6415

MSD Distributor
https://www.holley.com/products/ignition/distributors/

MSD Blaster Coil
https://www.holley.com/products/ignition/ignition_coils/coils/ Holley Sniper EFI https://amzn.to/2DMNiiN

If you're interested in more behind the scenes content be sure to follow us on Instagram and Facebook at

https://www.instagram.com/official710garage/

https://www.facebook.com/Official710garage-181521332512319/?ref=br_rs

If you're interested in some behind the scenes stuff be sure to follow us on Instagram and Facebook at
https://www.instagram.com/official710garage/
https://www.facebook.com/Official710garage-181521332512319/?ref=br_rs

Check out our sponsors:
Our Patreon Page - https://www.patreon.com/user?u=25803488

https://teespring.com/stores/710-garage for all of your automotive attire, and wearable gear!

Tube Buddy ( tubebuddy.com ) for the very BEST tools in the trade to help make the most out of your youtube content. Use our code to get the inside link!
https://www.tubebuddy.com/710garage

Cotes Coatings - @cotescoatings on IG/FB for all of your tire/powder coating needs

Dynamic Laser Fab -@dynamiclaserfab on IG/FB for all of your laser cutting and sheet bending requirements.