CNC - simple G code drill operation into soft plastic
This video shows a basic drill operation using a few lines of G code.
The spindle was manually adjusted into position using Chilipeppr software before starting the operation.
I found it fairly quick to program just automate 1 drill operation then go the the next location and stop. If nothing went wrong, just click the run button again to start the next hole..
Here is G-code with additional spindle automation and lots of comments:
(Drill holes and go to next position to prepare for next hole.)
(Drill bit size #23, 20-55 RPM. Soft plastic)
(Only drill ? holes at a time to allow clearing of shavings)
(Set bit about 1/4" above work piece)
G20
M03 (SPINDLE ON clockwise)
G04 P5.0(Wait for spindle to ramp up)
G91 G01 F20 Z-0.50 (Drill hole - G91 is incremental mode, G01=move at feedrate F, G00 is move at max rate)
G91 G00 Z0.50 (raise drill out of material)
G91 G00 X1.00 (Go to hole 2 location 1" on x axis)
(repeat as needed for more holes)
(End of drilling)
M05 (stop spindle)
M02 (end program)
-
0:32
Electronic Investigation
3 years agoCNC aluminum with simple G code -early testing
1043 -
3:06
Reuters Innovation
3 years agoPaving the way: Kenyan recycles plastic into bricks
168 -
0:28
Rich_Stadler
4 years ago $0.02 earnedCnc plastic routing
87 -
16:40
MGSHAF2
3 years agoA SIMPLE HOW-TO!
1422 -
0:47
5DogsInc
3 years agoSimple Joy!
99 -
3:55
LearnHowToQuilt
3 years ago $0.01 earnedSimple Table Runners
1331 -
3:44:17
SilverFox
20 hours ago🔴LIVE - FPBC #6 - LOTR Fellowship of the Ring - Part 1
103K12 -
5:48:49
NeoX5
17 hours agoShocktober 2024: Blair Witch [PC] | Rumble Gaming
115K -
9:01:29
Chi-Town Gamers Livestreams
19 hours ago $1.20 earnedGears of War: Judgment Ep. 3 | Then Dragonball Sparking Zero
112K8 -
6:14:41
SwitzerlandPlayIT
23 hours agoCastlevania - Lords of Shadow - Gabriel Belmont Knows How To Use His Whip...
117K10