Robotics: Testing out the Myoware Muscle Sensor, Arduino Feather, & Isolator

4 years ago
138

This was a test run of a MyoWare muscle sensor that I hooked to a Feather board, isolator, and my arm. I loaded the code into it and started it up!

The MyoWare muscle sensor uses electromyography (EMG) placed on the skin surface to measure the electrical activity produced my muscle cells. By measuring the potential or voltage difference between the two electrodes it sends the output signal to the screen as a value or a graph (electromyogram).

Note: I purchased these products except the MyoWare sensor (Christmas gift). No sponsored or donated equipment or software has been provided in this video.

SUPPORTING CHALLENGEYOURSELF.BLOG
If you'd like to support my work please head over to my Patreon or SubscribeStar pages:
https://www.patreon.com/bePatron?u=5696236
https://www.subscribestar.com/challengeyourself

FOLLOW CHALLENGEYOURSELF.BLOG
Facebook: https://www.facebook.com/ChallengeYourselfblog-100962358137299
Twitter: https://twitter.com/challen18646532
Reddit: https://www.reddit.com/user/challengeyourselfmb
LinkedIn: https://www.linkedin.com/in/michaelbemiss/

Loading comments...