Prusa MK3/S SD card fix not reading card or print stopping
Here is my referral link if you would like to sign up for a Rumble account.
https://rumble.com/register/gkmakeit/
When I would insert my SD card into the slot the fit was getting sloppier as time went on. This caused the printer to not recognize when the card was inserted and would not read it. It even caused my printer to stop during prints because it lost connection with the SD card. After digging into it I found that the thin sheet metal frame surrounding the SD card was starting to "deform" from normal use. After putting this part in I haven't had anymore problems with the SD card. If you're having similar problems hope this works for you.
Part files,
https://www.prusaprinters.org/prints/15388-prusa-mk3-sd-card-slot-fix-not-reading-the-card-at
https://www.thingiverse.com/thing:3345508
DISCLAIMER
GKMAKEIT assumes no liability for bodily or property damage or injury incurred as a result of any of the information contained in this video. GKMAKEIT recommends safe practices when working with all devices, equipment and tools and recommends everyone follow manufacture instructions and safety guidelines.
Any injury, damage or loss that may result from improper use of these devices, equipment, tools or the information contained in this video is the sole responsibility of the user and not GKMAKEIT. Only attempt these projects if you can accept personal responsibility for the results, do at your own risk.
-
12:09
gkmakeit
3 years agoPrusa 3d printer mk3 heatbed flatness level check and fix
418 -
4:11
ALLCHECKOUT
3 years agoMy GCODE Files Don't Show Up On My 3D Printer When I Insert The SD Card (Or I Can't See The Name)
29 -
0:58
Quest for Gear
3 months agoTascam Model 24 CARD READ ERROR - A Possible Fix
19 -
7:17
GarageScience
1 year agoDIY 3D Printer Case ~ An Easy Enclosure to Improve 3D Printing Quality
58 -
11:38
fixitfastelectronics
9 months agoBrother MFC Printer 0b error. Print Unable 0B. Turn the Printer Off then Back on Again. PART 1
12 -
3:17
Computer Quick Tips
3 years ago $0.02 earnedInternal Memory Card Readers Are Bad! What I Use Instead
81 -
0:59
Gear Report Maker
5 months ago3D print not sticking to the bed? Solved!
19 -
19:00
stuffchat
2 months agoPANTUM P2200 Mono Laser Printer: Fast printer 20 pages per minute, Processor 600MHz, Memory 64MB
17 -
14:32
fintech
1 year agoBiqu B1 troubleshooting & repair, bad X endstop broken SD card, Grinding on home
1 -
31:39
Taylormark3
9 months ago3d printing problems
61