How to Mount the EGW Tikka T3x TAC A1 Scope Mount

Mounts Available Here:
https://www.egwguns.com/scope-mounts-rings/standard-rifle-scope-mounts/?cat=511

In this episode, George shows you how to remove the factory Tikka T3x TAC A1 scope mount and replace it with one of our mounts.

Modification of your firearm may nullify the manufacturer's warranty. We always recommend any gun work be performed by a qualified and competent gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

The handguard must be removed by unscrewing the screws that hold it on. Next, remove the screws holding the mount in place on the receiver. Do not forget to remove the screw in the front of the mount that holds it in to the handguard ring. Carefully pry the original mount off of the receiver. There are pins installed in the mount which will need to be installed in your new 20 or 30 MOA mount.

The screws we provide with this mount are T10.