Pipe Stress Analysis & Piping Engineering Services over USA and Canada

Little P.Eng. for piping Engineering services proudly present our capabilities in Pipe Stress Analysis & Piping Engineering across Canada; especially in Alberta, British Columbia, Saskatchewan and Ontario. We provide pipe stress analysis as a specific service or as part of our broader piping engineering and design packages. Thermal effects are not an afterthought – we develop designs that optimize pipe flexibility, support spacing, structural and nozzle loads and other factors for an integrated system.

Pipe stress analysis is concerned with the prevention of overstressing pipes, skids, vessels, flanges, bolting, gaskets, valves, relief devices, fittings, hangers and supports

Typical Problem Areas

Pipe hanger/support failure

Equipment support structure failure

Verification of unfired pressure vessel design

Blast resistance

Pressure surge damage

Our Expertise in Piping Design & Pipe Stress Analysis Service

Little P.Eng. for Engineering Services offers a complete range of piping, skid, pressure vessel and tank storage engineering services. We specialize in mechanical detail design of piping, skids, pressure vessels, shell and tube heat exchangers, including the supply of detail drawings for fabrication.

If it comes to Piping Design and Pipe Stress Analysis problems, Meena Rezkallah is your answer for expert piping engineering solutions. By utilizing industry leading software like Caesar II, CADWorx for routing, Little P.Eng. for Piping Engineering Services offers a wide range of piping engineering services including the following:

Pipe Stress Analysis

Our Piping Engineering Services offers pipe stress capability for onshore and offshore installations complying with international codes (e.g. ASME B31.3, ASME B31.4, ASME B31.8, CSA Z662), services include:

Static design or Static Pipe Flexibility Analysis (operating, wind, seismic analyses, fatigue evaluation, Pressure, Weight, Thermal Expansion, Wind & Snow loads etc.)

Dynamic design (modal time history and harmonic analyses)

Vibration & Shock Analysis

Water Hammer Analysis (Surge Analysis)

Pump Start-up & Shut-down Analysis

Seismic Analysis

Support Selection and design

Spring Hanger Design

Flange Leakage Checks

Generation of Pipe Isometric Drawings

Design of non-standard components (Tees, Elbows, Weldolets, etc.)

Hot Tapping designs and analysis

We can perform pipe stress analysis in accordance to any International recognized Piping Standard.

Pipe Support Engineering

Little P.Eng. offers a complete pipe support design service. Little P.Eng. can develop pipe support standards that address clients' needs, using the clients' basis of design, early in the project. Our Professional Engineers will assist clients in selecting the most economical pipe support and spring hanger systems and advise on component material usage to minimize weight. Our Licencee Engineers can also provide factory supervision during fabrication and installation.

Little P.Eng. for Engineering Services proudly presents its Licensed Professional Canadian Piping Stress Engineers; Located in Calgary Alberta, we serve our clients across Canada. Our professional piping stress engineers have a bachelor's degree in mechanical / structural engineering and province licence (P.Eng.) in Alberta, Saskatchewan, British Columbia and Ontario. We review, validate, certify and stamp piping and structural packages.

Located in Calgary Alberta; We serve our Clients across Canada. Please Contact Us to get a free quote.

[email protected]
+1 (587) 802-4050

https://www.littlepeng.com/single-post/2020/07/01/pipe-stress-analysis-piping-engineering-services-alberta-british-columbia-saskatchewan-on