3D Printed Motor Housing on Compass Magnet Motor

This motor housing is 170mm by 170mm on the base and twice that in height. It was printed with a brand new Bambu Lab A1 mini 3D printer.
That's about 7 inches square on the table which is much smaller than the old motor housing/support structure that was made of 14 inch diameter hoops and an 8 by 10 wood base.
It held up pretty well to the motor's vibrations without any signs of falling over. The upper half and lower half are held together with pins/dowels that are also 3D printed and had to be done about 3 times before I got a good fit.

Stay tuned:)