Gen 2 Toyota Tacoma Suspension Flashark Struts Install Tips and Review

In this video we go over the steps to remove existing shock strut on a Gen 2 Tacoma and replace them, in this case with struts provided by Flashark. I do go over the provided struts and give you an overview as well as the results in a brief test drive.

On a quick note, the sequence I use here should be applicable to any vehicle that has front suspension struts and certainly applies to gen 3 Tacoma's.

For anyone interested, below is a paid affiliate link to Flashark, which has a pretty decent selection of aftermarket automotive parts. They carry suspension, exhaust and other performance parts.
https://tinyurl.com/342spxp2

Get a 15% discount if you use this code at checkout:
DIY15

00:00 Introduction
01:25 Removing the Sway Bar Link
01:45 Safety!
01:57 Disconnecting Brake Line Brackets
02:17 Removing the Brake Caliper
02:37 Disconnecting the Upper Ball Joint
03:01 Removing the 3 Upper Strut Bolts or Nuts
03:50 Removing the Strut Lower Bolt
05:56 Remove the Strut!
07:06 Installing New Strut and Reassembly
07:32 Test Drive
08:18 Wrapping it Up

#strut
#toyota
#tacoma
#Flashark
#FlasharkRacing
#FlasharkPerformance
#exhaustsystem
#CoiloverSuspension
#carparts
#carperformance
#aftermarketparts
#exhaustcutout
#CarEnthusiast
#carlovers