Premium Only Content

How a 9mm case is made
This is the beginning of the process. Here you see a transfer press with two inputs and two outputs. The input are brass cups that are pressed out on the two monster presses at the beginning of the line. From there the cups are washed, annealed, and then pickled before being polished. After polishing they’re ran through highspeed inspection machines to confirm diameter, wall thickness, overall length etc. A hardness test is done to confirm they’re the right spec before heading into this transfer press. This press is where the case is drawn out, head stamp, prime pocket and flash hole is put in. Later down the line it’s cut to final length and the extractor groove is turned into it.
A lot of steps to make everything in house. But this is the only way we can hold such high standards and tight tolerances.
-
1:01:11
VINCE
2 hours agoNATO Caves And America First Wins Again | Episode 73 - 06/26/25
86.3K45 -
LIVE
The Big Migâ„¢
2 hours agoBazzel Baz, ‘BLACKLIST’, CIA Operative, Warrior, Rescuer, Author
6,568 watching -
LIVE
LFA TV
4 hours agoLFA TV ALL DAY STREAM - THURSDAY 6/26/25
2,866 watching -
1:09:26
Dear America
3 hours agoFAKE NEWS GOING TO JAIL!! They Are LYING About Iran And We Can Prove It!
175K122 -
LIVE
Badlands Media
9 hours agoBadlands Daily: June 26, 2025
5,171 watching -
LIVE
Wendy Bell Radio
6 hours agoOBLITERATED
8,768 watching -
45:17
Randi Hipper
1 hour agoUSE BITCOIN FOR YOUR MORTGAGE! MAJOR NEWS
11.9K -
LIVE
FusedAegisTV
18 hours agoPersona 5X Worldwide Release! FIRST LOOK | New Gacha
100 watching -
LIVE
LumpyPotatoX2
1 hour agoHunting the Showdown - #RumbleGaming
32 watching -
22:05
The Rad Factory
3 hours agoMy F1 Caught Fire at the Race Track
13.8K1