3D Printing - Unboxing & testing a Removable PEI Build Surface vs. Sticker - Part 1

In this video series I review a removeable flexible PEI (polyetherimide) build plate and compare it to the removeable build plate with a sticker.

PEI requires very little maintenance yet has strong adhesive properties compared to a sticker.

Part 1 covers unboxing, installation, leveling, and first PLA test print.
Part 2 covers, removing supports, testing printing PETG, printing with a raft, large surface print, fixing a 1 layer print failure, narrow base with no brim, keeping the corners down after lots of flexing to remove parts.

Link to product I printed using PETG (Star Wars: Outer Rim board game Dashboards) on my Etsy Store:
https://betacygnidesigns.etsy.com/listing/1135987049/star-wars-outer-rim-board-game

Link to product I printed using PLA with a Narrow Base and no Brim (Star Wars Dice Tower: Millennium Falcon at Black Spire Outpost) on my Etsy Store:
https://betacygnidesigns.etsy.com/listing/874764996/star-wars-dice-tower-millennium-falcon

Flashforge Guider II on Amazon:
https://www.amazon.com/gp/product/B077QLTFF4/

These are the spatulas I used to help remove the pieces from the print bed:
https://smile.amazon.com/gp/product/B075SLTY8B/

These are the tweezers I used to help remove dripping filament from the print head:
https://smile.amazon.com/gp/product/B0845SKD7Z/

This is the wire brass brush I use to clean the nozzle tip:
https://smile.amazon.com/gp/product/B01J2BS92S/

These are the 0.4mm needles I use to clean the nozzle:
https://www.amazon.com/gp/product/B0797XV8ZK/

OpenSCAD website:
https://www.openscad.org/

I used Simplify3D slicer software for the test:
https://www.simplify3d.com/

-------------------
Link to my Etsy Store:
https://www.etsy.com/shop/BetaCygniDesigns

---------------------
End Screen Video Acknowledgement: Cosmic Reef Video produced by NASA and the Space Telescope Science Institute (STScI).
https://hubblesite.org/contents/media/videos/2020/16/1277-Video