11 months ago

Installed radiator support.

Installed front fenders.

Mocked up electrical components for glove box panel.
This panel will contain the multiply modules for the DAKATO DIGITIAL dash gauges. Besides standard gauges
there will be trans temp, oil temp, diff temp, outside temp, and compass
Fabricated ECU panel to mount on top of trans tunnel.

Discussed module and fuse placement on the board
Researched and wrote down how everything will work and be hooked up for the Holley and Dakota digital systems

Fit driver and passenger doors and adjusted for door gap repair.

Final installation of dash components

Prep and paint front portion of roll bar for installation.
Installed 2 front points and headache roll bar back into vehicle
Prepped roll cage floor pads (removed primer powder coating)
Welded roll cage and pillar panel designed and mocked up gusset that will be welded from the front bars to the A pillar

Started on trunk fitment and gapping.
Trunk lid gap set to 3/16"

Loading 1 comment...