Chapter 51 1970 TransAm Clone - Post primer assembly

Installed front suspension
Safety wired brake rotors
Installed front rotors and bearings
Finalized front suspension torque and pins
Installed rear suspension.
Installed steering column.
Safety wired rear Wilwood hats and rotors.

Finalized front brakes and hubs
Double checked safety wire
Installed rear axle backing plates
Assembled rear axle drum brakes.
Installed rotors assembly
Adjusted caliper for pad clearance.
Pad to caliper clearance procedure was preformed at all four wheels.
Installed gunny wheels and lower vehicle to ground level
Sanded roof and backseat panel in prep for sound and heat insulation coating.

Sanded interior in prep for seam seal and sound insulation.

Installed engine on engine stand
Prepped for oil pan replacement
Moved engine & trans out of 810 and stage for next procedure (engine assembly / installation).

Finish sanding interior surfaces
Clean and dust interior for seam sealing
Apply expanding foam between inner and outer roof structures, package tray and blast shield and between firewall and inner cowl panels.
Seam seal inner floors and blast shield
Start masking for sound and heat insulation coatings.