Layout Command Control 2 - Node Configuration

Part 2 of a two part series where I walk through how I configure tortoise control of routes with push buttons using Layout Command Control.

This video deals specifically with configuring the lines in the Tower LCC. I'm a layman, not an Electrical Engineer so I may not have all the terminology right but this is designed more as an overview than a "how to."

At the end of the video (24:14) I do a final explanation of how I understand LCC and the concept of Produced Events and Consumed events which is the bread and butter of LCC. If you are only mildly curious about running your layout with electronics this is a goo place to skip to, as it's a final summary.

List of components I use, all are from http://www.rr-cirkits.com/index.html

LCC Power point
LCB USB Buffer
Tower LCC
SMD-8
Tortoise Adapter Boards (TAB)
Button Quick-Links
Break Out Quick-Link
Cab servo cables
10 wire Ribbon Cable
10 pin IDC plugs.

Not seen in this video but also used:
BOD-8 (block occupancy detector)
Signal LCC

You can support me at https://www.buymeacoffee.com/ottercreek
https://www.facebook.com/profile.php?id=100064558609534