Layout Command Control 1 - Push Button Route Control with LCC (1)

Can you run your layout in a similar way that you run your DCC trains? The answer is yes. This is part one of a two part series where I attempt to explain how I configure the system I use to control my layout components. Layout Command Control (LCC) is a fantastic way to integrate various components of your layout like turnouts, push-buttons, block detection, and signaling.

I give an overview of the components I use and a comprehensive walk though of how I make use of LCC to create routes for trains with push-buttons.

You can support me at https://www.buymeacoffee.com/ottercreek
https://www.facebook.com/profile.php?id=100064558609534

List of components I use, all are from http://www.rr-cirkits.com/index.html

LCC Power point
LCB USB Buffer
Tower LCC
SMD-8
Tortoise Adapter Boards (TAB)
Button Quick-Links
Break Out Quick-Link
Cab servo cables
10 wire Ribbon Cable
10 pin IDC plugs.

Not seen in this video but also used:
BOD-8 (block occupancy detector)
Signal LCC