Dad-Builds: Deadpool Helmet Print Stream Part 2

Check out the Beginnign of a Multi-Part (Literally) Deadpool Helmet Printing Stream!

I am also testing out how long Rumble Studio will allow a stream to go on for!

I a May pop in when I get up in the morning around 6 AM PST

Print Stats:

Printer: Bambu Labs Carbon X1
Material: Bambu Labs PLA Basic Red
Nozzle: .4mm
Build Plate: Bambu Labs Textured PEI Plate
Hot End Temp: 220 C
Bed Temp: 55 C
Print Speed: 300 mm/s
Layer Thickness: .14mm

If you like watching 3D prints gone and on I hope you enjoy the show! If not, I will be putting together a timelapse and assembly video with clips from this and the setup you can find here on the same channel in the future so check back!

If you enjoy these builds, streams, and maker content, please consider supporting the channel:

https://streamelements.com/professorsavagedad/tip

Ad:

Dads of all kinds need a damn fine cup of coffee, pick one up for yours today by following this link below and check out CoffeeBrandCoffee's entire selection.

Plus get 10% off your order with Code DadCast!

https://coffeebrandcoffee.com/discount/DadCast?ref=DadCast