Make Your Own Chewing Gum Box LED Night Light - Part 1

Get ready to build this electronics project! This is the first video in a two part series of videos that shows you how to build The Chewing Gum Box LED Night Light detailed on the Motbots website. In this video we'll go from the breadboard prototype detailed on the website (link below) to the PCB board, to make a permanent circuit for our LED night light.

Get out your components (parts list on website and below) and your solder iron, because we're going to build us a neat project!

Video for Blog Page: "Make Your Own Chewing Gum Box LED Night Light"
Project Page and Schematics: https://motbots.com/make-a-chewing-gum-box-led-night-light/
Description: This is video 1 of 2 for The Chewing Gum Box LED Night Light project.
Website: https://motbots.com

PARTS LIST:
Extra Refreshers® Chewing Gum Box: https://www.extragum.com/refreshers
PCB Prototype Boards: https://amzn.to/4eetBAj
LED Kit: https://amzn.to/4bElmv1
Resistor Kit: https://amzn.to/4amcwRt
SPST Rocker-Switch: https://www.jameco.com/z/1901-1103-Cherry-SPST-Rocker-Switch-ON-OFF-2-Pin_2172738.html
9V Battery Snap Connector: https://amzn.to/4dARfXj
9V Battery: https://amzn.to/4dHiQG3
Breadboard: https://amzn.to/3QM1Fta
Jumper Wire Kit: https://amzn.to/3QN5UVl
Helping Hands: https://amzn.to/4bKxJpg
Solder Iron: https://amzn.to/3ytn04w

EARNINGS DISCLAIMER:
Motbots may earn an affiliate commission if you purchase something through recommended links.