342 RPM with 3D Prints 9v Battery Clips for Compass Magnet Motor
2 months ago
42
We are continuing to make minor improvements to the Compass Magnet Motor by using some 3D printed parts.
If you are patient to watch to near the end of the video you will see a 5 second interval slowed to 0.125 x slow motion and can count 28.5 turns.
This is nearly as fast as the motor has ever gone. Our hopes are to get up to 700 RPM by improving the alignment of axles and motor as well as the balance.
You will see it starts to wobble at higher speeds. Also to be considered are the harmonics of the vibration which make it shake a lot as it reaches top speed.
Stay tuned:)
Loading comments...
-
6:03
MagneticPropulsion
2 months agoCompass Motor Longer Upper Axle No Bearings 3D Prints 330 RPM
83 -
22:13
MagneticPropulsion
2 months ago3D Prints 9v Battery Clips for Compass Magnet Motor 5 Steady Lower Disc of Armature with Weights
41 -
10:58
GARAGE54
2 months agoWe use magnets as pistons - what will happen?
341 -
40:03
Kurenai5000
2 months agoTrying out a 3d printer and making small electronics
18 -
18:35
findfixxflip
2 months agoBMW E90-E92 (2005-2013) COILOVER INSTALL (MAX SPEEDINGSRODS )
7 -
7:25
Ascension Tools
2 months ago $0.05 earnedHow to Make Orgonite - Ancient Measurements & Coil Types
71 -
14:28
Death Toll Racing
2 months ago $0.01 earnedE11: Rear cross member for coil over mounts on Project 4x4 1965 Pontiac Safari Wagon
9 -
57:38
Kurenai5000
2 months agoRepairing, building and tuning the deconstructed motor
5 -
4:26
FreeEnergyConcepts
2 months agoCENTRIFUGAL VERTICLE SPIRAL WHEEL.
6 -
22:42
hashtagChatter
2 months agoMachining a BETTER Parting Tool Holder Pt1
24