Installing the Heat Hog Quick-Connect Extension Hose From 20 Pound LP Tank to Heater. 04/23/2024

Installing the Heat Hog 10-foot-long GC-00670 Quick-Connect Extension Hose for the 20-Pound Liquid Propane Tank. It does not fit into the same receptacle as the 1-pound Cylinder. There is a smaller brass fitting port located in the Left side of the compartment for the "Quick-Connect " Receptacle on the hose. Slide the Hose Receptacle onto the port until it locks into place. You may need to move the ring on the Hose Receptacle down slightly to unlock the connector, then release to lock the connector onto the port on the Heater. Double-Check to make sure it is fully connected. Attach the Coupling Nut on the opposite end of the Hose to the LP Cylinder Valve. Turn the Cut-Off Valve Counterclockwise to open the tank and pressurize the hose (Left to Loosen-ON, Right to Tighten-OFF). I had to press and hold the Pilot-Light Button down on the heater for several minutes to Prime the 10-Foot-LongHose and get the Heater to light. After that, it lit right up and works great! I really like it and no more having to change-out the little 1-pound cylinders every few hours when running it continuously.