Laser Gbrl Laser Continuously Turned ON FIX Makerbase
3 months ago
1
A lot of people face problem with there laser maker base board, when they plug in the power supply the laser is turned on by itself and it would not turn off automatically. To fix this problem of laser continuously flashing. Check that if you have plugged in your laser pin where it says "Laser" that is right next to the 12 volt power port. and put it in the G & S that is the TTL output. That way it will connect your laser with ground and signal connections and will fix the signalling issue of laser.
#lightburn #fix #Gbrl #cnc #laser
Loading comments...
-
LIVE
Battleground with Sean Parnell
2 hours agoAn Earth Shattering Week in American Politics w/ Bryan Dean Wright
1,959 watching -
LIVE
Revenge of the Cis
2 hours agoEpisode 1352: Blow Away
3,925 watching -
19:42
TENET Media
1 hour agoEyewitness To Trump's Assassination UNIMPRESSED With Security | Matt Christiansen
4.81K6 -
1:04:40
In The Litter Box w/ Jewels & Catturd
19 hours agoDems Torch Democracy | In the Litter Box w/ Jewels & Catturd – Ep. 609 – 7/22/2024
57.9K27 -
1:07:03
vivafrei
2 hours agoABJECT CRIMINAL NEGLIGENCE! Summary of Kim Cheatle Congressional Hearing! Viva Frei Vlawg
55.2K140 -
3:05:53
The Quartering
6 hours agoJoe Biden Incapacitated? Won't Even Finish His Term? Secret Service Testifies & It's Bad!
86.1K67 -
DVR
Film Threat
8 hours agoVERSUS: STAR WARS IS DONE & WILL MARVEL MAKE A COMEBACK AT SAN DIEGO COMIC-CON? | Film Threat Versus
17K -
33:31
Stephen Gardner
2 hours ago🔴Kamala Has PANIC ATTACK after Trump Surges ahead!
38.7K50 -
1:34:16
Fore Play Golf
19 hours agoXANDER SCHAUFFELE WINS THE OPEN CHAMPIONSHIP - FORE PLAY EPISODE 683
32.4K1 -
LIVE
FusedAegisTV
6 hours agoBetter To Die, And Be Born Again Inside Their Cycle (Monica's Candor) - Xenoblade Chronicles 3 Pt. 9
235 watching