300PRC: Neck Tension, Ball Micrometers, bushing dies and Neck Turning
3 months ago
571
In this video I describe how Neck Tension is related to consistent velocities and what tools can be used to help achieve low SD and ES when making ammo. Tools that I use: Forster Bushing dies, iGaging Ball Micrometer and K&M neck turning kit. These tools are all related to the amount of force that "holds the bullet" in the case. Just one more thing to be more consistent and get better results when making match ammo.
Loading comments...
-
7:10
Ricky Ace Range Review
2 months ago $0.06 earned300PRC Neck Turning with the K&M tool
508 -
7:12
Archeryrob shooting and reloading
3 months ago $0.01 earned9mm Cast Hollow points with 7/8 Bhn hardness
12 -
6:03
MagneticPropulsion
2 months agoCompass Motor Longer Upper Axle No Bearings 3D Prints 330 RPM
86 -
20:32
God, Guns, & Family Man
2 months agoPowder Charges: How to work up a load (EXTREME RELOADING ep. 12)
55 -
3:30
possumpopper89
3 months agoGel Test .45 Colt Gold Dot and PDX1
58 -
6:48
The Official UltiMAK Channel
2 months ago $0.01 earnedMeasuring your AK piston tube (gas tube) for an UltiMAK mount
14 -
3:15
The Rogue Banshee
3 months agoHi Point 1095 10mm Carbine Review: Power and Reliability?
491 -
10:02
SilencerSyndicate
2 months ago $0.12 earnedSuppressor Back Pressure Test: Huxwrx, SilencerCo, Dead Air, KGM, Surefire, & More
1792 -
16:38
Archeryrob shooting and reloading
2 months ago $0.06 earnedReloading 9mm Cast Hollow points
142 -
18:32
God, Guns, & Family Man
3 months agoPowder Charges and Electronic Scales (EXTREME RELOADING ep. 11)
401